Storing tools on the boat is always a compromise. On one hand they should be easily accessible, and on the other they tend to just get chucked in a box or plastic tray, and dumped in the bottom of a locker because space on a boat is always at a premium. Then when you do need some tool or other,o you finally pull the tool box out only to find out that all your tools are covered in rust. I have mitigated these problems to a large extent by only buying good quality tools, spraying them with WD40, and then storing them in an airtight box. I thought I was pretty particular, till I saw this Hylas 54 with super-dooper tool storage in the main salon. Impressive yes, but I think this is a bit of a waste of space. Also given the size of boat there were not that many tools in there - a basic tool kit at best.
The bottom picture shows another storage solution and one that I use myself. Although this is in my workshop at home it's an idea that works equally well on a larger boat. Lengths of PVC pipe are cut on the chop saw and screwed to a convenient wall or bulkhead, both fast and cheap. Some tools, such as bolt cutters do not require caps on the bottom of the tube but others, such as those used to hold screwdrivers and suchlike, do. There are two ways to go with the caps, either buy the plastic end caps where you buy the pipe and glue them on; easy and quick. Or do as I do and use the correct size hole saw to make a plywood disc on the drill press which is then epoxied into the end of the tube; easy and cheap. You'll need to get the right size hole saw, the local Home Depot or other tool store should have a selection just make sure that the inside diameter of the saw and pipe are the same size.
Comments